User manual

Psion Teklogix 7535/7530 Hand-Held Computer User Manual 261
Chapter 6: Tekterm Application
Split Screen
Block Cursor
When this parameter is enabled (set to “Y”), the cursor is presented as a flashing
block. When “Block Cursor” is set to “N”, the cursor is presented as a flashing
underline character.
Use increment
When “Use increment” is enabled (set to “Y”) and the cursor is moved off the
display, the screen contents shift by the values specified in the “X-increment” and
“Y-increment” parameters.
X-increment
This parameter determines the number of spaces the screen shifts once the cursor
moves out of view. The value assigned here doesn’t take effect until “Use
Increment” is set to “Y”.
Y-increment
This parameter determines the number of spaces the screen shifts once the cursor
moves out of view. The value assigned here doesn’t take effect until “Use
Increment” is set to “Y”.
6.18.1 Split Screen
This parameter allows you to split the display view so that more than one
application screen can be displayed at the same time. The split screen parameters,
“Type” and “View IDs”, are used to tailor the screen view for your needs.
Type And View IDs
The “Type” parameter determines how a screen will be split. The 7535/7530
supports up to four application screens. The “View IDs” parameter determines
which application screens will be displayed in each pane of the split screen.
“Moving Between Split Screens” on page 263 describes how to move the cursor
from one split screen to the next.
Type 2 Way |||
View IDs A
04 Split screen