User's Manual

Psion Teklogix NETBOOK PRO User Manual 25
Chapter 2: Getting Started
Power Properties
Switch to Stand-By
In Stand-By state, the NETBOOK PRO turns off the display, but the programs
and NETBOOK PRO hardware remain active. Stand-By is activated when the time
specified in the Switch to Dim and the Switch to Stand-By options have elapsed
without any activity. The NETBOOK PRO then begins to monitor the Suspend time.
Figure 2.14 Power Schemes: Switch To Stand-By Menu
Press any key or tap the screen to bring the unit out of Stand-By state.
Switch to Suspend
Once the time specified in the Switch to Dim and the Switch to Stand-By states have
elapsed, the NETBOOK PRO begins to count down the time specified in the Switch
to Suspend option. When the time in the Suspend option elapses, the unit enters
Suspend state.
In Suspend state, the NETBOOK PRO CPU suspends all activity, turns off the
display, and goes into a low power state. The state of the device (RAM contents)
is preserved.
Select Suspend from the Start Menu or press the Fn and Esc keys together to put
the NETBOOK PRO into Suspend state. The NETBOOK PRO may be configured
to allow entry into Suspend state if external communications connections are active;
these options can be set in the Advanced tab of the Power Properties dialogue.
Press the Esc/On key to wake up the unit. You can also enable the unit to wake from
Suspend when a number of external events occur, by checking the appropriate
option box in the Advanced tab of the Power Properties dialogue.
Note: When the NETBOOK PRO is in suspend state, any network connection is
broken. To resume, you must re-establish the network connection.