User manual

Chapter 5: Configuration
Protocol Tab
102
Psion Teklogix 8525/8530 Vehicle-Mount Computer User Manual
5.6.3 Protocol Tab
Figure 5.35 Protocol Tab
Enable Cellular Protocol
The value assigned to this parameter must be identical to the value assigned to the
corresponding parameter in the Psion Teklogix Network Controller, Wireless
Gateway or Base Station. A warm reset of the 8525/8530 is required before this
parameter can take effect.
If Enable Cellular Protocol is disabled (unchecked), the options in the Cellular Radio
Address frame are displayed in grey text indicating that they cannot be accessed.
Cellular Radio Address
Auto Radio Address
If Auto radio address is enabled, the 8525/8530 requests an automatically assigned
radio address. Manual radio address is displayed in grey text indicating that it cannot
be accessed.
Manual Radio Address
The value entered in the Manual Radio Address parameter is used to identify the
8525/8530 over the radio link. A unique value from 1 to 3840 must be assigned for
each unit.
Note: This parameter is set to ‘0’ (an out-of-range value) by default to block