User manual

Chapter 6: Tekterm Application
Radio Parameters
186
Psion Teklogix 8525/8530 Vehicle-Mount Computer User Manual
6.16 Radio Parameters
Important: Radio parameters should not be changed from their factory
settings without a clear understanding of your system.
The 8525/8530 is equipped with an 802.11b radio.
• Press [F1] to display the ‘Radio’ sub-menu.
• Press [F1] to access the ‘802.11’ sub-menu.
• Set ‘802.IQ v1’ to ‘Y’ to activate these parameters. and press [F1] to
display ‘802.IQ v1’ parameters.
802.IQ v1
When 802.IQ v1 is set to “Y”, the attached sub-menu of parameters is enabled.
Auto Radio Addr
If this parameter is enabled (set to “Y”), a request is sent to the network controller to
assign a radio address to the vehicle-mount computer radio.
If “Auto Radio Addr” is set to “N”, the value entered in the “Radio Address”
parameter is used. (Refer to "Radio Address" in this section for details about
manually assigned radio addresses.)
Important: Ensure that all 8525/8530s grouped in the system use the same
addressing process – that is, if you choose to use automatic
radio addressing, use this addressing process for all units
802.11 »
03
Radio
802.IQ v1 N »
04
802.11 DS SS
Auto Radio Addr Y Y/N
Radio Address 0 1-3840
Initial RTT 0 0-1000
Protocol Type 2457 1501-65535
Range
802.IQ v1
05