User manual

Psion Teklogix 8525/8530 Vehicle-Mount Computer User Manual 211
Chapter 6: Tekterm Application
Xmit Modes
Kbd lock
When this parameter is disabled (set to “N”), the 8525/8530 does not lock the
keyboard after a block mode transmission. When enabled (set to “Y”), the keyboard
is locked after a transmission. The application program must unlock the keyboard
by resetting the Keyboard Action Mode (KAM), using the Reset Mode (RM) or
Enable Manual Input (EMI) controls.
Xmit key
When this parameter is disabled (set to “N”), the key that causes the 8525/8530
vehicle-mount
to transmit is not sent to the host as part of the transmitted data. When enabled
(set to “Y”), the key that causes a transmission is sent after the page data has
been sent to the host. This parameter applies only to block mode.
FETM
When the Format Effector Transfer Mode (FETM) parameter is disabled (set to
“N”), Format Effectors are inserted in data sent to the host or included in data when
transferred to the console or serial ports. When enabled (set to “Y”), the Format
Effectors are not inserted into the data sent to the host and are not included in the
data transferred to the console or serial ports.
GATM
When the Guarded Area Transfer Mode (GATM) parameter is disabled (set to “N”),
only unguarded data is transmitted to the host or transferred to the console or
serial ports. When enabled (set to “Y”), both guarded and unguarded data can be
transmitted to the host or transferred to the console or serial ports.
MATM
When the Multiple Area Transfer Mode (MATM) parameter is disabled (set to “N”),
only the selected area containing the cursor can be transmitted to the host or
transferred to the console or serial ports. When enabled (set to “Y”), all selected
areas can be transmitted to the host or transferred to the console or serial ports.
This mode is significant only if the Selected Area Transfer Mode (SATM) is disabled.