User manual

Chapter 6: Tekterm Application
Kbd Modes
212
Psion Teklogix 8525/8530 Vehicle-Mount Computer User Manual
SATM
When the Selected Area Transfer Mode (SATM) parameter is disabled (set to “N”),
the selected areas defined by SSA/ESA and DAQ can be transmitted to the host or
transferred to the console or serial ports. When enabled (set to “Y”), the full contents
of the buffer can be transmitted to the host or transferred to the console or serial ports.
TTM
When the Transfer Termination Mode (TTM) parameter is disabled (set to “N”), the
cursor position determines the end of the string that can be transmitted to the host
or transferred to the console or serial ports. When enabled (set to “Y”), the cursor
position is ignored.
EOL chars
This string entry parameter specifies a string of up to 8 characters that are sent after
each line in a block transmission. If the parameter is not used, the rules specified in
“Transmitted Data Stream” are used to determine end of line characters.
EOB chars
This string entry parameter specifies a string of up to 8 characters that are sent after
each block transmission.
6.20.1.4 Kbd Modes
Arrow mode
This parameter determines whether arrow keys move the cursor within a field or
between fields. When set to “field”, pressing an arrow key causes the cursor to
move to the next field in the direction of the arrow. When set to “cursor”, pressing
the [LEFT] and [RIGHT] arrow keys move the cursor within the current field.
Arrow mode cursor cursor, field
Echo mode Smart Smart, Local, Host
DEL key DEL BS, CLEAR
BKSP key BS DEL, CLEAR
PrintScreen key 16 1..255
Xmit Enter Y Y/N
Insert N Y/N
Newline N Y/N
Disable kbd N Y/N
DEC Cursor Keys cursor mode see text
05
Kbd Modes
Range