User manual

Psion Teklogix 8525/8530 Vehicle-Mount Computer User Manual 225

Chapter 6: Tekterm Application

Features

6.20.2.5 Features

Printer

The value assigned for the “Printer” parameter determines which port the print

command will use. The allowable options are: Any Available, 1st printer, 2nd

printer, 3rd printer, 4th printer and Disabled.

Binary print

When this parameter is enabled (set to “Y”), the page displayed on the 8525/8530

computer is spooled as is, except for trailing white-space removal. When disabled

(set to “N”), each line of the page displayed on the vehicle-mount is preceded by a

linefeed (LF) and followed by a carriage return (CR).

Queuing

This parameter enables and disables queuing mode (see “Queuing Mode” on

page 170). It also enables TESS procedures to be loaded into the 8525/8530. This

parameter should be enabled if local procedures and the ability to switch between

hosts within a TESS session are required. Changes to this parameter take effect only

after the 8525/8530 is reset.

Lcl Process – Save on Reset

The menu item “Local Process” has a sub-menu attached to it – “Save on Reset”.

When this parameter is enabled (set to “Y”), data stored in the 8525/8530 is saved if

the unit is reset. Local procedures are defined on page 169.

Printer Any Available Y/N

Binary print N Y/N

Queuing Y Y/N

Lcl Process Y » see text

Send Mile N Y/N

Next X N Y/N

Kbd Locked N Y/N

Remap Passthru N Y/N

Disable Beep N Y/N

Serial » see text

Features

Range