User manual

Psion Teklogix 8525/8530 Vehicle-Mount Computer User Manual 235
Chapter 6: Tekterm Application
Emulation
Enable Alarm
If this parameter is set to ‘Y’, the 8525/8530 emits a beep when the word ALARM
appears on the application screen, in the location specified by the “Command
Region” parameter.
Command Region Up & Down And Command Region Left & Right
The value assigned to the ‘Command Region Up’ and ‘Command Region Down’
parameters represent rows on the 8525/8530 screen. The allowable values range
from 0 to 24.
The value assigned to ‘Command Region Left’ and ‘Command Region Right’
parameters represent columns on the 8525/8530 screen. The allowable values range
from 0 to 80.
These four numbers represent the row and column addresses of the upper left corner
and the lower right corner of the command region. Currently, the only commands
supported in the command region are ALARM and FONT:
3274/Telnet Emulation
Fujitsu Host
If this parameter is set to ‘Y’, data is sent in Fujitsu format. Enabling ‘Fujitsu Host’
causes the standard IBM formatting codes (for start of field, setting buffers, etc.) to
be replaced by the codes used by Fujitsu host computers.
Fujitsu Host N Y/N
Intl EBCDIC N Y/N
Nulls in Fields N Y/N
IP for SysReq N Y/N
BRK for Attn N Y/N
LU Name Enabled N Y/N
LU Name see text
Features » see text
FKEY0-7 » see text
FKEY8-15 » see text
FKEY16-23 » see text
FKEY24-31 » see text
FKEY32-39 » see text
Emulation
Range
05