User manual

Psion Teklogix 8525/8530 Vehicle-Mount Computer User Manual 251
Chapter 6: Tekterm Application
802.IQ v2
Important: Follow the steps outlined in “Configuring An IEEE 802.11
Radio” on page 19 for details about configuring your radio.
6.22.2 802.IQ v2
Important: For setup information about 802.IQ v2, refer to the “9400 and
9450 Network Controllers User Manual” and/or the “9150
Wireless Gateway User Manual”.
Port
“Port” specifies the UDP port used by 802IQ v2. The default value is 8888. Keep in
mind that the value assigned here must match the value set at the network controller.
Note: When using 802.IQ v2, make certain that the 8525/8530 “Net Mask”
matches the network controller net mask.
More Parameters
Important: The 802.IQ radio items listed in this menu are only available to
Psion Teklogix personnel.
Auto Radio Addr
If this parameter is set to “Y”, the 8525/8530 requests an automatically assigned
radio address.
Note: If ‘Auto Radio Addr’ is enabled (set to “Y”), any value assigned to the ‘Radio
Address’ parameter is ignored.
Port 8888 see text
More Parameters » see text
802.IQ v2
Range
04
Auto Radio Addr Y Y/N
Radio Address 0 1 to 3840
Initial RTT 100 500...5000
802.IQ v2 Parameters
Range
05