User manual
Psion Teklogix WAPro Vehicle Cradle User Manual4
To accommodate the service loop of the connector cable, leave
a 4” clearance at the bottom of the Vehicle Cradle. Leave a 7”
clearance at the top of the Vehicle Cradle to allow easy removal
of the WORKABOUT PRO. Refer to the detailed assembly
instructions that are packaged with the pedestal when selecting a
mounting location.
Note: A template for the Vehicle cradle rear mount system is
provided on the next page. Remove that page only - to use
this template.
Please be aware:
Before Psion Teklogix releases a product, our engineering team
exposes that product through a series of severe testing to ensure
it will survive in the rugged environments in which our products
are typically used. These tests usually include shock and vibra-
tion testing as well as IP testing for water and dust, electrical
shock, etc.
The third party should perform the same type of testing in order
to ensure the design will maintain the factory specications of
the product. If the third party company is unwilling to perform
the necessary testing and take responsibility for the affects of
the design, then we highly recommend using Psion Teklogix
designed and supported accessories.
If you elect to use a third party company produced cradle, Psion
Teklogix cannot take responsibility for the affects of that third
party product when it causes failure to our device.