User's Manual
Table Of Contents
- Peripheral Devices & Accessories 6
- 6.1 Carrying Accessories
- 6.2 The Battery
- 6.3 Adaptor Cable Options
- 6.4 Chargers And Docking Stations: General Information
- 6.5 CH4000 Desktop Docking Station
- 6.5.4 Cleaning The CH4000
- 6.5.5 Troubleshooting
- 6.5.5.1 Docking Station Does Not Seem To Power On.
- 6.5.5.2 The Ikôn Charge Indicator LED Stays Off.
- 6.5.5.3 The Ikôn Charge Indicator LED Is Fast Flashing Green.
- 6.5.5.4 Spare Battery LED Fast Flashes Green With A Battery Installed.
- 6.5.5.5 Spare Battery LED Does Not Turn On When A Battery Is Installed.
- 6.7 AC Wall Adaptor: Model No. PS1050 - G1
- 6.8 Automotive Power Adaptor: Model No. CH3050
- 6.9 The CH1000 Non-Powered Vehicle Cradle
- 6.10 The CH1005A Powered Vehicle Cradle
- 6.11 Scanners And Imagers
- 6.12 Bluetooth Peripherals
- Specifications 7
Ikôn Rugged PDA (Windows CE 5.0) User Manual 195
Chapter 5: Configuration
Imager
Imager Options
5.14.4 Imager
• Tap on the Scanner drop-down menu, and choose Imager.
5.14.4.1 Imager Options
TekImager Enabled
Setting this option to on enables the imager installed in your Ikôn.
Continuous Scan Mode
Setting this parameter to on keeps image capture active and continuously decoding as long
as the scanner button is pressed and held down.
Center Bar Code Only
When more than one bar code is visible in a single snap shot, this parameter allows you to
specify that only the centre image within the imager framing marker be read. When this pa-
rameter is set to on, the target dot is pointed at the centre image and only that image
is returned.
Max Number Barcodes
This parameter specifies the maximum number of bar codes the imager will attempt to
decode in an image. A maximum of 6 bar codes can be decoded at one time.
Note: This parameter must be disabled when reading Composite bar codes.