User's Manual

Chapter 6: Peripheral Devices & Accessories
Operation
228 Ikôn Rugged PDA (Windows CE 5.0) User Manual
6.6.3 Operation
6.6.3.1 Charging The Ikôn Battery
Insert the adaptor's DC power MINI FIT JR plug into the CH4004 rear DC input receptacle.
The adaptor LED should be ON when powered from the mains.
The CH4004 supplies DC power to enable the Ikôn internal fast charger. Normally, it takes
2.5 to 3.0 hours to charge the Ikôn 5000 mAh battery.
• During charge the Ikôn LED will be a slow flashing green.
• When the battery capacity reaches 95%, the LED turns solid green.
When installed in the docking station, the Ikôn battery charge LED will illuminate to indi-
cate the unit has external power and may charge the internal battery.
6.6.3.2 Connecting To The Ethernet Network
The rear-mounted RJ45 connector incorporates LEDs that indicate data traffic (see
Figure 6.7) when:
• The Ikôn is in the docking station and powered on;
• The docking station is powered by the AC adaptor;
• The docking station is connected to Ethernet network with a Category 5 cable plugged
into the RJ45 rear socket.
The green Link LED flashes to indicate the presence of data traffic. The yellow Speed LED
is steady ON when the network is 100 Mbps and OFF when the network is 10 Mbps.
Note: Battery charging continues whether the Ikôn is switched on or off.