User's Manual Part 1

Ikôn (7505) Rugged PDA Regulatory & Warranty Guide 7
Warning for Australia
The user needs to switch off the device when exposed to areas with potentially
explosive atmospheres such as petrol stations, chemical storage depots and
blasting operations.
Warning to Users
This product is a Class I/Class II laser product according to CDRH 21 CFR
1040.10 and 1040.11 and Class1/Class 2 laser product according to IEC
60825-1:1993+A1:1997+A2:2001
Laser Warnings
For your own safety, it is critical that you comply with the
following warnings:
Caution!
Do not look into the laser beam or point the beam at people or animals.
Caution!
Using controls or adjustments, or performing procedures other than those
specified herein may result in hazardous radiation exposure.
Caution!
The use of optical instruments with this product will increase
eye hazard.
Do Not Operate In An Explosive Atmosphere
Operating Psion Teklogix equipment where explosive gas is present may
result in an explosion.
Do Not Remove Covers Or Open Enclosures
To avoid injury, the equipment covers and enclosures should only be
removed by qualified service personnel. Do not operate the equipment
without the covers and enclosures properly installed.
Caution!
Danger of fire, explosion, leakage or other hazard if a battery is incor-
rectly handled, charged, disposed of or replaced.
All batteries recommended for this system have been qualified to
IEEE1725: 2006. Replace only with the same or equivalent type recom-
mended by Psion Teklogix. Dispose of used batteries according to the
instructions described in “The Battery” on page 9. Carefully review all
battery safety issues.