User's Manual

Table Of Contents
Chapter 6: Peripheral Devices & Accessories
Carrying Pouch
222 EP10 Hand-Held (Windows Embedded 6.5) User Manual
Attaching the Stylus Tether to the Retainer
1. If not assembled, thread the tether cord through the stylus as shown, pulling the
cord tight.
2. Thread the tether through the eyelet on the strap.
3. Pass the stylus through the tether loop and pull the tether snug.
4. Slip the stylus into the elastic holder, and you’re finished.
6.1.3 Carrying Pouch
A protective carrying pouch (Model No. TBD) is available for EP10. The pouch is equipped
with a belt clip to allow the operator to safely carry the EP10 when it is not in use.
Figure 6.3 EP10 Carrying Pouch
6.2 The Battery
The EP10 operates with a 3600 mAh, Lithium-Ion battery pack.
Back of Pouch
Belt Clip
Note: For information about inserting, removing and charging the battery, refer to “The
Battery” on page 12. For battery specifications, refer to “Lithium-Ion 3600 mAh
Battery Specifications” on page 265.
Preliminary Draft