User's Manual

Table Of Contents
D-2 EP10 Hand-Held (Windows Embedded 6.5) User Manual
Appendix D: Teklogix Imagers Applet
Predefined Presets
Every preset belongs to a preset type. The following preset types are available:
Imaging for photo capture.
Imaging for bar code decoding.
Symbology selection.
At any time, only one preset of each type can be designated as the user-selected
active preset.
D.2.1 Predefined Presets
Predefined presets are built into the imaging software and cannot be changed. The pre-
defined presets allow you to use the imager to perform specified tasks without having to
understand and set numerous variables. In almost all cases these predefined presets are
sufficient.
D.2.2 Bar Code Predefined Presets
These presets encompass the majority of the most popular bar codes and their subtypes. The
bar code decoding symbology predefined presets define which bar codes can be decoded.
The bar code decoding camera predefined presets determine how the bar code images are
captured
D.2.2.1 Bar Code Decoding Symbology Predefined Presets
The following presets select groups of similar bar codes for decoding.
Factory Default
This preset enables the decoding of frequently used bar codes.
My Default
This preset is synchronized with the Teklogix Scanners applet and contains all the symbolo-
gies selected using the Teklogix Scanner applet. For details on this synchronization see,
“Configuring Symbologies in the Teklogix Imagers Applet” on page D-17.
All
This preset enables the decoding of all bar codes that the imager can decode. For a descrip-
tion of these symbologies see “Imager” on page C-37.
Note: It is recommended that the default preset be used whenever possible.
Preliminary Draft