User's Manual

6 EP10 Hand-Held Computer & Accessories Regulatory & Warranty Guide
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician
for help.
Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate
the equipment.
The antenna(s) used for this transmitter must not be co-located or
operating in conjunction with any other antenna or transmitter.
Operation on the 5.15 - 5.25GHz frequency band is restricted to
indoor use only. The FCC requires indoor use for the 5.15 - 5.25GHz
band to reduce the potential for harmful interference to co-channel
Mobile Satellite Systems. The device is allowed to transmit on the
5.25 - 5.35 GHz, 5.47 - 5.725 GHz and 5.725 - 5.850 GHz bands when
associated with an access point (AP), in an outdoor environment.
RF Exposure Information (SAR)
This mobile phone meets the government's requirements for expo-
sure to radio waves. This phone is designed and manufactured not to
exceed the emission limits for exposure to radio frequency (RF)
energy set by the Federal Communications Commission of the U.S.
Government.
The exposure standard for wireless mobile phones employs a unit of
measurement known as the Specific Absorption Rate, or SAR. The
SAR limit set by the FCC is 1.6W/kg. Tests for SAR are conducted
using standard operating positions accepted by the FCC with the
phone transmitting at its highest certified power level in all tested
frequency bands. Although the SAR is determined at the highest cer-
tified power level, the actual SAR level of the phone while operating
can be well below the maximum value. This is because the phone is
designed to operate at multiple power levels so as to use only the
power required to reach the network. In general, the closer you are
to a wireless base station antenna, the lower the power output.
Draft1_for review