User's Manual

EP10 Hand-Held Computer & Accessories Regulatory & Warranty Guide 11
or electric shock. If an extension cord must be used,
make sure:
- The plug pins on the extension cord are the same number,
size, and shape as those on the charging device.
- The extension cord is properly wired and in good electrical
condition and that the wire size is larger than 16 AWG.
• For indoor use only. Do not expose the charging device to rain
or snow.
• Do not connect the Ethernet port of the accessory to
outdoor cables.
• Do not use the charging device if, after an overnight charge,
any of the batteries feel warmer than the charging device
housing. The charging device should be inspected by qualified
service personnel.
• When utilizing the USB port as a charging source, the EP10
shall only be connected to CTIA certified adapters, products
that bear the USB-IF logo or products that have completed
the USB-IF compliance program.
3.2 Imager & Laser Safety Instructions
Important: When equipped with an imager or scanner:
This product is a Class I/Class II LED/laser product
according to CDRH 21 CFR 1040.10 and 1040.11 and
Class1/Class 2 LED /laser product according to IEC
60825-1 2nd edition.
Warnings
For your safety, it is critical that you comply with the following
warnings:
• Caution! Do not look into the laser beam or point the beam at
people or animals.
• Using controls or adjustments, or performing procedures
other than those specified herein may result in hazardous
radiation exposure.
Draft1_for review