Instruction Manual Part 1

BlueTest Instruction Manual

bc01-an-047b

This material is subject to CSR’s non-disclosure agreement.

Page 16 of 56

BlueCore

Title BIT ERR1

Summary

Enables the receiver at a designated frequency (

LO Freq) with a

choice of low or high side modulation (

hi-side) and with a designated

attenuation setting

(RX Attenuation).

Returns a set of reports to the host:

g Number of data bits received (payload excluding FEC and CRC)

g Number of data bits that were in error. Assumes PRBS9 data

starting with 1FF in each packet

g Number of packets received

g Number of packets expected, based on txrx_freq (default

12500)

g Number of packets with header errors as reported by hardware

g Number of packets with CRC errors

g Number of packets with uncorrected errors (currently same as

CRC errors)

g Number of sync timeouts. Note that until a transmission is

received a long timeout is used, so this does not reflect the

number of packets expected

Each report has two unint32 values. First is value since last report,

second is summed over the last

bits_count (default =

1.6Mbits).

Reports are sent according to

report_freq set (default = 1

second). The times between receive slots and report frequency can

be set, and the count reset. Refer to Configuration Commands

section.

BIT ERR1 Example Display