User's Manual Part 2
Table Of Contents
- 4. General Maintenance
- 5. Support Services & Worldwide Offices
- Approvals
- Safety Summary
- Program License Agreements
- Microsoft's End User License Agreement
- Meetinghouse Data Communications, Inc. End User License Agreement
- End User License Agreement:
- Software License Terms:
- License Grant:
- Permitted Uses and Restrictions:
- High Risk Activities:
- Ownership:
- Termination:
- U.S. Government Restricted Rights:
- Export Law Assurances:
- Limited Warranty on Media: (if applicable)
- Disclaimer of Warranty on Software:
- Limitation of Liability:
- Government End Users:
- Controlling Law and Severability:
- Acknowledgement:
- MDC Acknowledgments:
- Complete Agreement:
Psion Teklogix WORKABOUT PRO Hand-Held Computer Quick Start Guide 35
Safety Summary
This equipment complies with Class B Part 15 of the FCC rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, includ-
ing interference that may cause undesired operation.
Changes or modifications not expressly approved by Psion Teklogix,
the party responsible for compliance, may void the user's authority
to operate the equipment.
1. FCC Information to Users
For Class B Unintentional Radiators:
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction manual, may
cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular instal-
lation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equip-
ment off and on, the user is encouraged to try to correct the interfer-
ence by one of more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between he equipment and receiver
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.