User's Manual Part 2

Chapter 6: Peripheral Devices & Accessories
Battery Charging–LED Behaviour
234 WORKABOUT PRO Hand-Held Computer With Windows Mobile 5.0 User Manual
6.7.5 Battery Charging–LED Behaviour
The quad docking station supplies DC power to enable the WORKABOUT PRO
G2 internal fast charger. Charge status is displayed on the hand-held LED
–the LED
turns red while the battery is being charged and turns green once the charge is
complete. If the battery is fully charged when the unit is inserted in the docking
station, the LED flashes red for less than a second and then turns green. Battery
charging continues whether the WORKABOUT PRO G2 is switched on or off.
It can take up to 5 hours to fully charge the internal battery.
6.7.6 Troubleshooting
The indicators, applications and drivers required to use and monitor the docking
station are installed on the WORKABOUT PRO G2
–no indicators or applications
are present on the docking station itself.
6.7.6.1 Network Link Unsuccessful
If a network link fails, the WORKABOUT PRO G2 application alerts the operator
that the link was unsuccessful.
6.7.6.2 Hand-Held LED Does Not Light When Docked
• Check that the quad docking station has power–is the Power LED on the
docking station illuminated?
• Try inserting the WORKABOUT PRO G2 in another well in the quad dock.
• Check for dirt or contamination on the docking contacts at the bottom of the
WORKABOUT PRO G2. Wipe the contacts with a damp cloth if necessary.
• Check the pogo pins inside the dock cradle for dirt. Gently wipe with a
damp cloth if they appear to be dirty or discoloured.
• Check that the pogo pins are not bent or damaged.
• Remove and reinsert the WORKABOUT PRO G2 in the cradle, and check
that the latch is holding the unit in place (the pogo pins must be compressed
for proper contact).
• Make certain that the battery installed in the WORKABOUT PRO G2 is
not defective.