User's Manual Part 1

WORKABOUT PRO G2 Hand-Held With Windows Embedded CE 5.0 User Manual 109
Chapter 5: Configuration
Manage Triggers
Add Key
Only existing trigger sources are shown in the Source combo-box. To add a new
source to this list, tap on the Add Key button. A dialog will pop up and allow you to
select the keyboard key to use as a trigger source.
Trigger-Press Type
You can enable either an Up/Down or Double Click response to a trigger press.
Normally, when a trigger (keyboard key, etc.) is pressed and released, a “trigger
down” event is sent to the “owner”—that is, the application receiving the trigger
press information—followed by a “trigger up”. If Double Click is chosen in this
menu, when the trigger is pressed, released, and then pressed again, a “double-click”
event will have occurred. If a mapping with the type Up/down has also been
configured for the same source, it will only receive the first set of trigger events.
Module Trigger
This identifies the driver or application receiving the trigger presses.
Show All Modules
By default, inactive owners are not shown. By checking this checkbox, all owners,
both active and inactive, are displayed.