User's Manual Part 1

WORKABOUT PRO G2 Hand-Held With Windows Embedded CE 5.0 User Manual 13
Chapter 2: Basic Checkout
Switching The Unit Off (Suspend)
The desktop screen is displayed.
Note: If the unit was already in use
–the unit may be off (suspend state)–press-
ing [ENTER/ON] ‘wakes’ the unit from this state. The screen in which you
were working prior to the suspend state is displayed.
2.2.2 Switching The Unit Off (Suspend)
• Press the [BLUE] key, and then press [ENTER/ON].
2.3 Calibrating The Touchscreen
Note: Keep in mind that the touchscreen function can be turned off (see
“Touch” on page 105).
The WORKABOUT PRO G2 touchscreen is factory-calibrated and ready-to-go;
however, over time the touchscreen operating parameters may change, and it may
need to be recalibrated for correct operation. Refer to “Calibrating The
Touchscreen” on page 45 for details.
2.4 Configuring The RA2041 802.11b/g Radio
Psion Teklogix supports an 802.11b/g Compact Flash (CF) wireless LAN radio
card, model number RA2041. It is a Direct Sequence Spread Spectrum radio.
If your WORKABOUT PRO G2 is equipped with an RA2041 CF radio, follow the
steps under “Summit Client Utility (SCU) For Model RA2041” below to set up this
type of radio for communication with a wireless LAN.
2.4.1 Summit Client Utility (SCU) For Model RA2041
This section describes the Summit Client Utility (SCU). The SCU provides the
utilities you will need to configure the Summit 802.11b/g Compact Flash radio
module, model number RA2041 so that it can communicate through a wireless LAN
effectively and securely.
2.4.2 Assigning The IP Address
Before launching the SCU, you need to configure how the IP address will be
obtained. If your network is not using a DHCP server, you will need to assign an
IP address.