User's Manual Part 1

Chapter 3: Getting To Know Your WORKABOUT PRO G2
WORKABOUT PRO G2 Indicators
46 WORKABOUT PRO G2 Hand-Held With Windows Embedded CE 5.0 User Manual
3.6 WORKABOUT PRO G2 Indicators
The WORKABOUT PRO G2 uses an LED (Light Emitting Diode), onscreen
messages and audio tones to indicate the various conditions of the hand-held, the
batteries, the scans and so on.
3.6.1 LED
A single, two-coloured LED is located on the upper-right side of the keyboard, just
above the [ON] key. When you press [ON], the LED flashes green to indicate that
the unit has been powered up. The LED table following outlines the behaviour of
the LED while the unit is docked in a charger.
Keep in mind that the application running on the WORKABOUT PRO G2 can
dictate how the LED operates. Review the documentation provided with your
application to determine LED behaviour.
If the unit is attached to an external power supply, the hand-held LED reflects the
battery charge status.
3.6.2 Audio Indicators
The audio speaker provides a variety of sounds when a key is pressed, a keyboard
character is rejected, scan input is accepted or rejected, an operator’s entry does not
match in a match field or the battery is low. To specify how you want your
WORKABOUT PRO G2 to respond under various conditions, refer to “Volume
And Sound Properties” on page 99.
The volume keys are located above [UP ARROW] and [DOWN ARROW]. The
increase volume key is labelled with a plus symbol and the decrease volume
key is labelled with a minus symbol .
LED Behaviour Charge Status
Solid Green Charge complete.
Fast Blinking Green
Charge in progress. Battery charged to less than 80%
capacity.
Slow Blinking Green Battery charged to greater than 80% of capacity.
Solid Red Temperature outside charge range (0° C to 50° C).
Blinking Red Battery is not charging. Battery fault.