User's Manual Part 1

WORKABOUT PRO Hand-Held Computer With Windows CE 5.0 User Manual 35
Chapter 3: Getting To Know Your WORKABOUT PRO
Switching The Hand-Held On And Off
• Quad Docking Station — (Model # WA4204-G2 for WORKABOUT PRO
C & Model # WA4304-G2 for WORKABOUT PRO S) can charge the
battery of up to four WORKABOUT PROs inserted in the docking station.
• Single Battery Charger (Model # WA3001-G1)—charges a single battery.
• Quad Battery Charger (Model # WA3004-G1)—charges up to four spare
High or Super-High Capacity WORKABOUT PRO battery packs.
It can take up to 5 hours to charge a battery. The WORKABOUT PRO intelligent
charging system protects the battery from over-charging by terminating the charge
process when the battery is at maximum capacity.
Note: Refer to “Monitoring The Battery And Maximizing Run Time” on page 47
for additional information about the battery.
Important: To avoid damaging the battery, chargers will not begin the charge
process until the battery temperature is between 0° C to 45 °C
(32° F to 113° F).
3.3 Switching The Hand-Held On And Off
Switching On The WORKABOUT PRO
Note: Whenever the battery cover is removed, an auto-shutoff switch is acti-
vated. The battery cover must be installed before the unit can be switched
on.
• Press the [FN/BLUE] key and then, press and hold down the [ENTER] key
for at least one second.
• When the LED flashes green, release the [ENTER] button.
If the unit does not power up, the power ON/OFF switch located in the battery
compartment may be set to OFF. In this case, you’ll need to remove the battery
cover and battery and slide the ON/OFF switch to ON.
The startup screen is displayed.
Note: If the WORKABOUT PRO is in suspend state, pressing [ENTER] ‘wakes’
the unit from this state. The screen in which you were working before the
computer entered suspend state is displayed.“Wakeup” on page 102
describes how you can assign other ‘wakeup’ keys.