User's Manual

Chapter 6: Tekterm Application
Keyboard Modes
150Psion Teklogix 7530 Hand-Held Computer User Manual
Macro keys <M5> to <M6> are colour coded in blue print above macro keys <M1>
and <M2>.
• To access <M5>, press the <BLUE> key followed by <M1>.
• To access <M6>, press <BLUE> <M2>.
6.3 Keyboard Modes
6.3.1 View Mode
Placing the 7530 keyboard in Vie w mode allows you to choose another screen font and
to pan the contents of the screen.
To place the computer keyboard in View mode:
• Press <CTRL> <ALT> <V>.
When the hand-held is in View mode, the onscreen message –
View – is displayed in the
status area at the bottom of the screen.
Keep in mind that this is a toggle key combination – pressing <CTRL> <ALT> <V>
a second time turns View mode off.
6.3.1.1 Changing Font Sizes
To cycle through the available fonts (with the unit in View mode):
• Press the <F> key.
Each time you press the <F> key, the font on the screen changes. Once you’ve
displayed the appropriate font:
• Press <CTRL> <ALT> <V> to exit Vi ew mode.
6.3.1.2 Panning The Screen Contents
If the content of a screen is too large to fit in the margins of the 7535 display, the
content can be panned or shifted to bring the information outside the margins into
view. Normally, the Arrow keys move the cursor around the screen in the direction
of the arrow pressed. However, if the 7535 is operating in View mode, the <LEFT>,
<RIGHT>, <UP> and <DOWN> arrow keys pan the entire content of the screen
rather than the cursor.
• Press <CTRL> <ALT> <V> to place the 7535 in View mode. An onscreen
message – View – is displayed in the status area of the screen.