User's Manual Part 2

Chapter 6: Tekterm Application
802.IQ v2
246
Psion Teklogix 7535 Hand-Held Computer User Manual
Port
“Port” specifies the UDP port used by 802IQ v2. The default value is 8888. Keep in
mind that the value assigned here must match the value set at the network controller.
Note: When using 802.IQ v2, make certain that the 7535 “Net Mask” matches
the network controller net mask.
More Parameters
Important: The 802.IQ radio items listed in this menu are only available to
Psion Teklogix personnel.
Auto Radio Addr
If this parameter is set to “Y”, the 7535 requests an automatically assigned radio
address.
Note: If ‘Auto Radio Addr’ is enabled (set to “Y”), any value assigned to the
‘Radio Address’ parameter is ignored.
Radio Address
Important: “Radio Address” only takes effect when “Cellular” is
enabled (set to “Y”).
The value entered in the “Radio address” parameter is used to identify the 7535
hand-held over the radio link. A unique value from
1 to 3840 must be assigned for
each 7535.
Auto Radio Addr Y Y/N
Radio Address 0 1 to 3840
Initial RTT 100 500...5000
802.IQ v2 Parameters
Range
05