User's Manual Part 2

Chapter 6: Tekterm Application
Sup. Password
186
Psion Teklogix 7535 Hand-Held Computer User Manual
Font Chg
When “Font Chg” is set to “Y”, operators at the User level can change the font size
of their 7535s.
6.15.4.3 Sup. Password
Note: Only a Supervisor or Teklogix level password can change the Supervisor
password.
The supervisory password is set at the factory to 123456. You should change the
default password to better protect the 7535 settings. When you’ve changed the
password, write down the new password and file it in a secure place. If the
password is lost, the parameters can only be changed by Psion Teklogix personnel.
Your password can have up to six alphanumeric characters. To change your
password:
• Position the cursor on “Sup. password” and type a new value in the string
entry field.
• When you’ve completed the change, press <ENTER> and then, press <F4>
– the SAVE function key – to save your change.
Important: When you change your password, set all the 7535s to the same
password.
6.15.4.4 Allow Teklogix
Setting this parameter to “Y” allows Psion Teklogix personnel to use their support
level password to access 7535 parameters. If ‘Allow Teklogix’ is set to “N”, only
your supervisory level password can be used to access the parameters.
Warning: If you set this parameter to “N”, the Psion Teklogix support level
password will be rejected. Keep in mind that if you then lose your
supervisory level password, you will need to clear the entire config-
uration setup on all terminals to gain access to the parameters
menu.