User's Manual Part 2

Psion Teklogix 7535 Hand-Held Computer User Manual 203

Chapter 6: Tekterm Application

Xmit Modes

Xmit Wait

This parameter determines the length of time the 7535 collects keystrokes before

transmitting them to the host. This value is speciﬁed in increments of one 10th of a

second (i.e., a value of 10 represents 1 second). If 0 (zero) is selected, the computer

transmits only according to the “Xmit Count” parameter.

Note: If the 7535 is not in local edit mode, the <ENTER>, arrow, <CTRL>,

and function keys cause an immediate radio transmission regardless of

the “Xmit Wait” parameter setting.

Dev Attr

This string entry parameter speciﬁes a device attribute string. This string can be up

to 16 characters long. The computer sends this string to the host when it receives a

DA or DECID control. The example shown in the “Xmit Modes” screen sample on

page 202 is the device attribute sent to a VAX, identifying the Psion Teklogix hand-

held computer as a VT220 terminal. This parameter may or may not be set,

depending on the requirements of the host computer.

Auto-Answer

This string can be up to 30 characters long and is sent by the 7535 as a reply to

an “ENQ” character from the host. The “Auto-Answer” string is programmable in

the same manner as the keyboard macros. For example, this string can be used to

automatically send the username and password when logging into the host. Refer

to "Macro Control Panel" beginning on page 181 for additional details about

macros.

7 bit

When this parameter is disabled (set to “N”), the hand-held computer transmits 8 bit

controls. When enabled (set to “Y”), the hand-held transmits 7 bit controls. This

parameter applies to character mode, block mode, and media copy mode.