User's Manual
Table Of Contents
- Table of Contents
- Introduction 1
- Basic Operation 2
- 2.1 Omnii Features
- 2.2 Preparing Omnii for Operation
- 2.3 Switching Omnii On and Off
- 2.4 Resetting Omnii
- 2.5 Attaching Carrying Accessories
- 2.6 Calibrating the Touchscreen
- 2.7 Configuring Your Wireless Network
- 2.8 Wireless Networking
- 2.9 Checking the Scanner
- 2.10 Data Transfer between Omnii and a PC
- 2.11 Voice – Using the Phone Dialer
- Getting To Know Your Omnii 3
- Windows Embedded CE 6.0 4
- Configuration 5
- 5.1 Remote Desktop Connection
- 5.2 The TekTerm Application
- 5.3 Pocket PC Compatibility
- 5.4 The Control Panel
- 5.5 Control Panel Applications: Basic Setup
- 5.6 Bluetooth® Setup
Chapter 5: Configuration
Keyboard Properties
102 Psion Teklogix Omnii Hand-Held Computer User Manual
5.5.5.2 Keyboard Backlight
•In the Keyboard Properties dialog box, open the Backlight tab.
Intensity
This parameter is used to adjust the light intensity of the Omnii keyboard backlight. Sliding
the bar to the left darkens the keyboard backlight intensity, and sliding it to the right lightens
the intensity.
ON For
The value chosen from this drop-down menu determines the duration of time that the key-
board backlight stays on after the last user action (keypress or scan trigger).
5.5.5.3 Keyboard One Shot Modes
•In the Keyboard Properties dialog box, open the One Shots tab.
Note: The keypad backlight maximum brightness will decrease over time as it ages. Use
mid-range intensity settings when possible to extend the backlight lifespan. When
the backlight starts to dim, use this parameter to make it brighter.
Note: Tapping in the checkbox next to ‘When using external power, keep the backlight
always ON’ forces the keypad backlight to remain on when the unit is operating
with external power.
Draft 1