User's Manual
Table Of Contents
- Table of Contents
- Introduction 1
- Basic Operation 2
- 2.1 Omnii Features
- 2.2 Preparing Omnii for Operation
- 2.3 Switching Omnii On and Off
- 2.4 Resetting Omnii
- 2.5 Attaching Carrying Accessories
- 2.6 Calibrating the Touchscreen
- 2.7 Configuring Your Wireless Network
- 2.8 Wireless Networking
- 2.9 Checking the Scanner
- 2.10 Data Transfer between Omnii and a PC
- 2.11 Voice – Using the Phone Dialer
- Getting To Know Your Omnii 3
- Windows Embedded CE 6.0 4
- Configuration 5
- 5.1 Remote Desktop Connection
- 5.2 The TekTerm Application
- 5.3 Pocket PC Compatibility
- 5.4 The Control Panel
- 5.5 Control Panel Applications: Basic Setup
- 5.6 Bluetooth® Setup
Chapter 5: Configuration
Power Properties
120 Psion Teklogix Omnii Hand-Held Computer User Manual
WWAN Power Mode
This menu allows you to enable power to your WWAN radio, and whether or not the radio
will turn off when Omnii enters Suspend Mode.
5.5.8.6 Battery Health
The Battery Health service provides an estimate of battery health based on a number of dif-
ferent measurements, beyond just capacity.
•In the Power Properties dialog box, open the Battery Health tab.
Current Battery Health
The Current Battery Health default values are shown here as ***** (Excellent), *** (Used),
and * (Battery should be replaced). If you tap on the battery icon in the taskbar, a pop-up
screen will show the state of the battery. The image below shows the default Excellent status
screen.
Important: Battery Health is an estimate and should not be depended on to provide a
100% account of battery condition.
Draft 1