User's Manual
Table Of Contents
- Table of Contents
- Introduction 1
- Basic Operation 2
- 2.1 Omnii Features
- 2.2 Preparing Omnii for Operation
- 2.3 Switching Omnii On and Off
- 2.4 Resetting Omnii
- 2.5 Attaching Carrying Accessories
- 2.6 Calibrating the Touchscreen
- 2.7 Configuring Your Wireless Network
- 2.8 Wireless Networking
- 2.9 Checking the Scanner
- 2.10 Data Transfer between Omnii and a PC
- 2.11 Voice – Using the Phone Dialer
- Getting To Know Your Omnii 3
- Windows Embedded CE 6.0 4
- Configuration 5
- 5.1 Remote Desktop Connection
- 5.2 The TekTerm Application
- 5.3 Pocket PC Compatibility
- 5.4 The Control Panel
- 5.5 Control Panel Applications: Basic Setup
- 5.6 Bluetooth® Setup
Chapter 2: Basic Operation
Preparing Omnii for Operation
14 Psion Teklogix Omnii Hand-Held Computer User Manual
2.2 Preparing 7545 for Operation
2.2.1 The Battery
Omnii is powered by a Lithium-ion Smart Battery pack, 5000 mAh—Model ST3000.
Battery packs shipped from the factory are charged to approximately 40% and must be fully
charged prior to use. Batteries can be charged using a variety of chargers and docking sta-
tions. For detailed information, see “Battery Details” on page 41.
Replacing the Battery Pack
Figure 2.6 Omnii Battery
Important: Before charging the battery, it is critical that you review the battery safety
guidelines in the Omnii Hand-Held Computer Regulatory & Warranty
Guide (PN 8000191).
Important: Always switch the unit off before changing the battery (see “Switching
Omnii On and Off” on page 15). However, assuming the default power
saving parameters and battery reserve level have not been altered, battery
swap time is a minimum of 5 minutes—you will not lose data if the battery
is replaced within this time frame.
2 - Battery Compartment
Contacts
Battery Top
Battery Bottom
1 - Release Latch
3 - Guide Tabs
4 - Latch Tabs
3
3
3
1
1
2
4
4