User's Manual
Table Of Contents
- Table of Contents
- Introduction 1
- Basic Operation 2
- 2.1 Omnii Features
- 2.2 Preparing Omnii for Operation
- 2.3 Switching Omnii On and Off
- 2.4 Resetting Omnii
- 2.5 Attaching Carrying Accessories
- 2.6 Calibrating the Touchscreen
- 2.7 Configuring Your Wireless Network
- 2.8 Wireless Networking
- 2.9 Checking the Scanner
- 2.10 Data Transfer between Omnii and a PC
- 2.11 Voice – Using the Phone Dialer
- Getting To Know Your Omnii 3
- Windows Embedded CE 6.0 4
- Configuration 5
- 5.1 Remote Desktop Connection
- 5.2 The TekTerm Application
- 5.3 Pocket PC Compatibility
- 5.4 The Control Panel
- 5.5 Control Panel Applications: Basic Setup
- 5.6 Bluetooth® Setup
Chapter 2: Basic Operation
Configuring Your Wireless Network
Psion Teklogix Omnii Hand-Held Computer User Manual 19
The Omnii touchscreen feature is factory-calibrated and ready-to-go; however, over time the
touchscreen's operating parameters may change, and it may need to be recalibrated for
correct operation. Refer to “Calibrating the Touchscreen” on page 50 for details.
2.7 Configuring Your Wireless Network
Omnii contains an integrated 802.11b/g radio module. The Wi-Fi Config application is used
to configure the radio for one or more wireless network profiles. To configure the radio,
follow the steps outlined under the following heading “Wireless Networking”.
To configure your Bluetooth settings, please go to “Bluetooth® Setup” on page 134.
To see the radio specifications, please go to “Wireless Radios” on page 215.
2.8 Wireless Networking
The Wi-Fi Config application is used to configure the Omnii 802.11a/b/g/n radio for one or
more wireless network profiles. A network profile contains settings for SSID (Service Set
Identifier) and security options.
To launch the Wi-Fi Config application:
• Tap on Start>Programs>Wi-Fi Config.
The Wi-Fi Config screen is displayed.
Note: In most situations, the configuration of your 802.11 radio will require parameter set-
ting and access keys from a network administrator.