User's Manual
Table Of Contents
- Table of Contents
- Introduction 1
- Basic Operation 2
- 2.1 Omnii Features
- 2.2 Preparing Omnii for Operation
- 2.3 Switching Omnii On and Off
- 2.4 Resetting Omnii
- 2.5 Attaching Carrying Accessories
- 2.6 Calibrating the Touchscreen
- 2.7 Configuring Your Wireless Network
- 2.8 Wireless Networking
- 2.9 Checking the Scanner
- 2.10 Data Transfer between Omnii and a PC
- 2.11 Voice – Using the Phone Dialer
- Getting To Know Your Omnii 3
- Windows Embedded CE 6.0 4
- Configuration 5
- 5.1 Remote Desktop Connection
- 5.2 The TekTerm Application
- 5.3 Pocket PC Compatibility
- 5.4 The Control Panel
- 5.5 Control Panel Applications: Basic Setup
- 5.6 Bluetooth® Setup
Chapter 3: Getting To Know Your Omnii
Indicators
Psion Teklogix Omnii Hand-Held Computer User Manual 51
3.4 Indicators
Omnii uses LEDs (Light Emitting Diodes), onscreen messages, vibrations, and audio tones
as indicators.
3.4.1 LEDs
Omnii is equipped with four coloured LEDs. This section outlines what these LEDs
indicate.
Figure 3.3 LED Status Indicators
3.4.1.1 Battery Charge Status LED
The far left LED is reserved for battery charge status. This indicator is active even when the
hand-held is inserted in a docking station (and in suspend mode) so that the charge status of
the battery can be detected easily.
Important: If an LED is illuminated in red, the operator should be cautious as this gen-
erally indicates an abnormal operating condition or active laser emission.
3. GPS Status
4. Scanner Status
1. Battery Charge Status
2. Operating System Status
1
2
3
4