User's Manual
Table Of Contents
- Table of Contents
- Introduction 1
- Basic Operation 2
- 2.1 Omnii Features
- 2.2 Preparing Omnii for Operation
- 2.3 Switching Omnii On and Off
- 2.4 Resetting Omnii
- 2.5 Attaching Carrying Accessories
- 2.6 Calibrating the Touchscreen
- 2.7 Configuring Your Wireless Network
- 2.8 Wireless Networking
- 2.9 Checking the Scanner
- 2.10 Data Transfer between Omnii and a PC
- 2.11 Voice – Using the Phone Dialer
- Getting To Know Your Omnii 3
- Windows Embedded CE 6.0 4
- Configuration 5
- 5.1 Remote Desktop Connection
- 5.2 The TekTerm Application
- 5.3 Pocket PC Compatibility
- 5.4 The Control Panel
- 5.5 Control Panel Applications: Basic Setup
- 5.6 Bluetooth® Setup
Chapter 4: Windows Embedded CE 6.0
The PsionVU Desktop Shell
76 Psion Teklogix Omnii Hand-Held Computer User Manual
Warm Reset
The Warm Reset option resets the hand-held, leaving all saved files and registry settings
intact. Any unsaved data is lost.
Cold Reset
The Cold Reset option resets the hand-held (see page 17). Any files not stored in permanent
memory are lost; however, the registry settings are saved.
4.5 The PsionVU Desktop Shell
The appearance and actions of the desktop can be changed by tapping on the PsionVU Shell
icon on your desktop, which activates the PsionVU shell.
Figure 4.7 Switch to PsionVU Shell
After resetting the Omnii, the desktop appearance will be very different. The programs are
accessed with finger (or stylus) taps and swipes. If there are more applications than shown
on one screen, a white animated dot will be present on the side of the screen in the direction
Note: Omnii will be reset if you choose to switch shells.
Draft 1