User's Manual
Table Of Contents
- Table of Contents
- Introduction 1
- Basic Operation 2
- 2.1 Omnii Features
- 2.2 Preparing Omnii for Operation
- 2.3 Switching Omnii On and Off
- 2.4 Resetting Omnii
- 2.5 Attaching Carrying Accessories
- 2.6 Calibrating the Touchscreen
- 2.7 Configuring Your Wireless Network
- 2.8 Wireless Networking
- 2.9 Checking the Scanner
- 2.10 Data Transfer between Omnii and a PC
- 2.11 Voice – Using the Phone Dialer
- Getting To Know Your Omnii 3
- Windows Embedded CE 6.0 4
- Configuration 5
- 5.1 Remote Desktop Connection
- 5.2 The TekTerm Application
- 5.3 Pocket PC Compatibility
- 5.4 The Control Panel
- 5.5 Control Panel Applications: Basic Setup
- 5.6 Bluetooth® Setup
Chapter 4: Windows Embedded CE 6.0
Restoring the Windows Classic Shell
Psion Teklogix Omnii Hand-Held Computer User Manual 79
4.5.1 Restoring the Windows Classic Shell
The default Desktop appearance and actions can be restored by tapping on the PsionVU
Shell icon in the Favourites Bar.
Figure 4.8 Shell Switch to Windows Classic Shell Desktop
4.5.2 Shutdown
Turning off Omnii places the hand-held into a power-saving suspend state. In this state, all
radios remain on, but the display, keyboard backlight and processor are switched off. When
Omnii is turned on from this state, operation resumes within a few seconds in the screen in
which you were working prior to suspend.
• Press the [FN] key, and then press the [ENTER/Power] key.
Note: Omnii will be reset if you choose to switch shells.
Important: If the word ‘FN’ is displayed underlined in the taskbar area at the bottom
of the screen, this key is locked “on” and Omnii will not switch off. Press
the [FN] key twice followed by [ENTER/Power] to switch Omnii off.
However, if you’ve set the mode to “Lock” (see “Keyboard One Shot
Modes” on page 102), Omnii can be turned off even when the [FN] key is
locked ‘on’.
Draft 1