User's Manual
Table Of Contents
- Table of Contents
- Introduction 1
- Basic Operation 2
- 2.1 Omnii Features
- 2.2 Preparing Omnii for Operation
- 2.3 Switching Omnii On and Off
- 2.4 Resetting Omnii
- 2.5 Attaching Carrying Accessories
- 2.6 Calibrating the Touchscreen
- 2.7 Configuring Your Wireless Network
- 2.8 Wireless Networking
- 2.9 Checking the Scanner
- 2.10 Data Transfer between Omnii and a PC
- 2.11 Voice – Using the Phone Dialer
- Getting To Know Your Omnii 3
- Windows Embedded CE 6.0 4
- Configuration 5
- 5.1 Remote Desktop Connection
- 5.2 The TekTerm Application
- 5.3 Pocket PC Compatibility
- 5.4 The Control Panel
- 5.5 Control Panel Applications: Basic Setup
- 5.6 Bluetooth® Setup
Chapter 4: Windows Embedded CE 6.0
Shutdown
Psion Teklogix Omnii Hand-Held Computer User Manual 81
Hard Reset
To execute a hard reset:
• Remove the battery.
• Using a coin, or other conductive item, connect pins 5 and 6 of the Omnii battery con-
tacts for at least 6 seconds.
• Replace the battery and power Omnii on. The terminal will boot as if from a cold reset.
Important: This procedure is recommended as a last resort, when all other
methods fail.
Pin 6
Pin 5
Draft 1