User's Manual
Table Of Contents
- Table of Contents
- Introduction 1
- Basic Operation 2
- 2.1 Omnii Features
- 2.2 Preparing Omnii for Operation
- 2.3 Switching Omnii On and Off
- 2.4 Resetting Omnii
- 2.5 Attaching Carrying Accessories
- 2.6 Calibrating the Touchscreen
- 2.7 Configuring Your Wireless Network
- 2.8 Wireless Networking
- 2.9 Checking the Scanner
- 2.10 Data Transfer between Omnii and a PC
- 2.11 Voice – Using the Phone Dialer
- Getting To Know Your Omnii 3
- Windows Embedded CE 6.0 4
- Configuration 5
- 5.1 Remote Desktop Connection
- 5.2 The TekTerm Application
- 5.3 Pocket PC Compatibility
- 5.4 The Control Panel
- 5.5 Control Panel Applications: Basic Setup
- 5.6 Bluetooth® Setup
Chapter 5: Configuration
Stylus Properties
130 Psion Teklogix Omnii Hand-Held Computer User Manual
5.5.10 Stylus Properties
•In the Control Panel, choose the Stylus icon.
5.5.10.1 Double-Tap
•In the Double-Tap menu, follow the directions to tailor the sensitivity of the stylus when
you tap on the touchscreen.
5.5.10.2 Calibration
Touchscreens rarely require recalibration. However, if your touchscreen has never been cal-
ibrated or if you find that the stylus pointer is not accurate when you tap on an item, follow
the directions below.
• Choose the Calibration tab, and then tap on the Recalibrate button.
Note: Touchscreen calibration may not be enabled on your unit. If your screen appears to
require recalibration, contact your supervisor.
Draft 1