User's Manual
Table Of Contents
- Table of Contents
- Introduction 1
- Basic Operation 2
- 2.1 Omnii Features
- 2.2 Preparing Omnii for Operation
- 2.3 Switching Omnii On and Off
- 2.4 Resetting Omnii
- 2.5 Attaching Carrying Accessories
- 2.6 Calibrating the Touchscreen
- 2.7 Configuring Your Wireless Network
- 2.8 Wireless Networking
- 2.9 Checking the Scanner
- 2.10 Data Transfer between Omnii and a PC
- 2.11 Voice – Using the Phone Dialer
- Getting To Know Your Omnii 3
- Windows Embedded CE 6.0 4
- Configuration 5
- 5.1 Remote Desktop Connection
- 5.2 The TekTerm Application
- 5.3 Pocket PC Compatibility
- 5.4 The Control Panel
- 5.5 Control Panel Applications: Basic Setup
- 5.6 Bluetooth® Setup
Chapter 2: Basic Operation
Resetting Omnii
Psion Teklogix Omnii Hand-Held Computer User Manual 17
Warm Reset
To execute a warm reset:
• Press and hold down the [FN] key and the [ENTER/Power] key simultaneously for a
minimum of four seconds.
A warm reset closes open applications; any unsaved data are lost. Installed programs and
saved data are preserved.
Cold Reset
To execute a cold reset:
• Press and hold down the [SYM] key, the [FN] key, and the [ENTER/Power] key,
simultaneously for a minimum of four seconds.
Bootloader
To implement the bootloader:
Note: You do not need to reset your Omnii after configuring the radio.
Note: As part of the normal Windows Embedded CE cold boot process, the screen may go
blank for a few seconds after the splash screen loading bar reaches the end. The
desktop is displayed after a few moments.
Important: This reset returns Omnii to factory settings.