User Manual

Chapter 2: Installation Requirements
Status Indicators (LEDs)
20
Psion Teklogix 9160 Wireless Gateway User Manual
2.2.4 Status Indicators (LEDs)
The high-performance 9160 has six status indicators on the front of the enclosure, as
shown in Figure 2.2 on page 19. The numbered and coloured LEDs on the front of
the unit indicate the operating status for each port, as described in Table 2.1.
2.1.5 Connecting A Video Display Terminal
An ANSI compatible video display terminal (e.g., DEC VT220 or higher), or a PC
running terminal emulation, is used for diagnostic purposes.
The terminal is connected to the RS-232 port on the 9160 (see Figure 2.2 on page 19).
This port is normally set to operate at 115,200 baud, 8 bits, 1 stop bit, no parity. To
comply with Part 15 of the FCC rules for a Class B computing device, only the cable
supplied (P/N 19387) should be used.
2.2 Changing The Configuration With A Web Browser
The 9160 Flash memory can be reconfigured remotely via the network using a standard
HTML Web Browser such as MS Internet Explorer (version 4.0 or later) or Firefox.
See Chapter 4: “Quick Steps For Setup And Launch” for instructions on changing
the parameters and general configuration settings.
LED
Number
Name Function Colour
1 Ethernet link Link indicator for 10BaseT/100BaseT:
ON = good link; OFF = no link
yellow
*
2 Ethernet activity Ethernet LAN activity (Rx/Tx) green
3 Radio 1 status Radio 1 activity (Rx/Tx) green
4 Radio 2 status Radio 2 activity (Rx/Tx) green
5 Not used Always off (unused) green
6 Power LED On solid = Unit powered
LED Off = No power to unit
green
*
LED 1 colour shows orientation of LEDs when viewed from a distance.
Table 2.1 9160 LED Functions: Front Enclosure