User Manual

Chapter 3: PreLaunch Checklist
Default Settings For The 9160 Wireless Gateway
24
Psion Teklogix 9160 Wireless Gateway User Manual
Network Name (SSID) “TEKLOGIX” for the Internal
interface
“TEKLOGIX Guest” for the Guest
interface
“Review / Describe The Access Point” on page 48
in “Configuring Basic Settings” on page 45
“Configuring “Internal” Wireless LAN Settings” on
page 110 in “Setting the Wireless Interface” on
page 105
“Configuring “Guest” Network Wireless Settings” on
page 111 in “Setting the Wireless Interface” on
page 105
Network Time Proto-
col (NTP)
None “Network Time Protocol Server” on page 197
IP Address 192.168.1.10
The default IP address is used if you
do not use a Dynamic Host Configura-
tion Protocol (
DHCP ) server. You can
assign a new static IP address through
the Administration Web pages.
If you have a
DHCP server on the net-
work, then an IP address will be
dynamically assigned by the server at
AP startup.
“Understanding Dynamic And Static IP Addressing
On The 9160 Wireless Gateway” on page 28
Connection Type Dynamic Host Configuration Protocol
(
DHCP )
If you do not have a DHCP server on
the Internal network and do not plan to
use one, the first thing you must do
after bringing up the access point is to
change the Connection Type from
“DHCP” to “Static IP”.
The Guest network must have a DHCP
server.
“Understanding Dynamic And Static IP Addressing
On The 9160 Wireless Gateway” on page 28
For information on how to re-configure the Connec-
tion Type, see “Configuring Internal Interface Ether-
net Settings” on page 102.
Subnet Mask None
This is determined by your network
setup and DHCP server configuration.
“The Ethernet (Wired) Interface” on page 97
Radio On “Configuring Radio Settings” on page 153
Option Default Settings Related Information
Table 3.1 9160 Default Settings