User's Manual

RFID Reader HF-AM2-G2 – User Manual
TS-A00350-A00 Page 8/19
III.2. Interface Board installation
Insert the bard as shown and screw the 4
provided screws
Plug the flex cable as shown
III.3. Reader Board installation
The reader board intends to fit in a specific endcap which depends on the desired configuration.
Each following paragraph describes how to assemble every configuration.
III.3.1. HF-AM2-G2 Endcap assembly
Here are the required parts
- A multipurpose endcap
- A rubber
- A sticker
Insert the reader board in the rubber Inject silicon on the 3 internal sides of the
endcap