User's Manual

ManualsBrandsPsion ManualsElectronicsRFID MODULE HF-T2-G2-SMOD

August 29, 2007

DPD A00301 A10 Sheet 1 of 5

WORKABOUT PRO RFID MODULE HF-T2-G2-XMOD

EXPANSION MODULE INSTRUCTIONS

Important: All Approval and safety information is outlined in the ‘Workabout pro G2

Handheld-computer User Manual’ – part number 8100140A. This manual is available on

our website www.psionteklogix.com through the Teknet extranet

Easily installable expansion modules for the WORKABOUT PRO allow you to customise this hand-held to

meet your specific mobile computing requirements. This chapter outlines how to install the RFID Module

HF-T2-G2-XMOD (this module is composed of one RFID Coupler HF-T2-G2-XMOD and one RFID

Antenna HF-A1-G2-XMOD).

Before installing a module in the WORKABOUT PRO G2, all power sources must be turned off.

• Remove the batteries. If your unit is using AC power, disconnect it.

• Slide the switch to position OFF to shut off internal battery power.

With the power shut down, you can install the RFID Module HF-T2-G2-XMOD.

• Remove and discard the two screws on the bottom of the metal frame.

• Put the RFID Coupler HF-T2-G2-XMOD in the same alignment of the expansion connector on the

WORKABOUT PRO. Apply slight pressure to snap the module into place on the hand-held.

Summary of content (5 pages)

PAGE 1
WORKABOUT PRO RFID MODULE HF-T2-G2-XMOD EXPANSION MODULE INSTRUCTIONS Important: All Approval and safety information is outlined in the ‘Workabout pro G2 Handheld-computer User Manual’ – part number 8100140A. This manual is available on our website www.psionteklogix.com through the Teknet extranet Easily installable expansion modules for the WORKABOUT PRO allow you to customise this hand-held to meet your specific mobile computing requirements.
PAGE 2
• • Use four new screws (M2 x 6 mm) provided to secure the module in place. Remove and discard the two screws on the top of the metal frame. • Slide the RFID Antenna HF-A1-G2-XMOD under the metal frame (with the spiral pattern facing up). • Connect the RFID Antenna HF-A1-G2-XMOD to the RFID Coupler HF-T2-G2-XMOD. • Use two new screws (M2 x 12mm) provided to secure the antenna on the metal frame. • Slide the switch to the position ON to turn power back on.
PAGE 3
WORKABOUT PRO RFID MODULE HF-T2-G2-XMOD RFID Regulatory Information August 29, 2007 DPD A00301 A10 Sheet 3 of 5
PAGE 4
August 29, 2007 DPD A00301 A10 Sheet 4 of 5
PAGE 5
IMPORTANT NOTE FOR NORTH AMERICA: The RFID must not be used whilst the host WORKABOUT PRO is being powered by the ac/dc adaptor. FCC Information to Users: This product and it antennas must not be co-located or operated in conjunction with any other antenna or transmitter. Radiation Exposure Compliance This product complies with the FCC RF exposure limits for an uncontrolled environment. For continued compliance, the product must not be held closer than 20 cm from the rest of the body.