User's Manual

ManualsBrandsPsion ManualsElectronicsRFID MODULE LF-AH1-G2

August 29, 2007

DPD A00285 A20 Sheet 1 of 5

ORKABOUT

RFID MODULE HF/LF G2

XPANSION

ODULE

NSTRUCTIONS

Important: All Approval and safety information is outlined in the ‘Workabout pro G2 Handheld-computer

User Manual’ – part number 8100140A. This manual is available on our website www.psionteklogix.com

through the Teknet extranet

Important: The WORKABOUT PRO G2 with the RFID option must not be held closer than 20 cm

from the rest of the body. This product must not be used in a holster or on a belt-clip.

Easily installable expansion modules for the WORKABOUT PRO G2 allow you to customise this hand-

held to meet your specific mobile computing requirements. This chapter outlines how to install the RFID

Module HF/LF G2.

Before installing a module in the WORKABOUT PRO G2, all power sources must be turned off.

• Remove the batteries. If your unit is using AC power, disconnect it.

• Slide the switch to position OFF to shut off internal battery power.

With the power shut down, you can install the RFID Module HF/LF G2.

• Connect the USB connector on the RFID Module.

• Slide the PCB guide in the Multi purpose End Cap.

• Slide the RFID Module in the PCB guide.

• Screw the stopper.

RFID Module HF-AM1-G2 RFID Module HF-T2-G2

RFID Module LF-AH1-G2

Summary of content (5 pages)

PAGE 1
WORKABOUT PRO G2 RFID MODULE HF/LF G2 EXPANSION MODULE INSTRUCTIONS Important: All Approval and safety information is outlined in the ‘Workabout pro G2 Handheld-computer User Manual’ – part number 8100140A. This manual is available on our website www.psionteklogix.com through the Teknet extranet Important: The WORKABOUT PRO G2 with the RFID option must not be held closer than 20 cm from the rest of the body. This product must not be used in a holster or on a belt-clip.
PAGE 2
• Remove the End cap at the top of the WORKABOUT PRO G2. • Connect the USB connector. • Slide the switch to the position ON to turn power back on. • Replace the end-cap and battery. For detailed instructions, pleased refer to the WORKABOUT PRO G2 Hand-Held Computer User Manual and to the RFID MODULE HF/LF G2 User manual. These manuals are available on our website www.psionteklogix.
PAGE 3
WORKABOUT PRO G2 RFID MODULE HF/LF G2 RFID Regulatory Information August 29, 2007 DPD A00285 A20 Sheet 3 of 5
PAGE 4
August 29, 2007 DPD A00285 A20 Sheet 4 of 5
PAGE 5
IMPORTANT NOTE FOR NORTH AMERICA: The RFID must not be used whilst the host WORKABOUT PRO is being powered by the ac/dc adaptor. FCC Information to Users: This product and it antennas must not be co-located or operated in conjunction with any other antenna or transmitter. Radiation Exposure Compliance This product complies with the FCC RF exposure limits for an uncontrolled environment. For continued compliance, the product must not be held closer than 20 cm from the rest of the body.