User manual

Psion Teklogix Omnii XT10 Hand-Held Computer User Manual C-59
Appendix C: Bar Code Settings
Non-Decoded Scanners
EAN 8
An addendum is a separate bar code, supplementary to the main bar code. This parameter
provides three options: Disabled, Optional and Required. Depending on the value chosen for
this parameter, an addendum is recognized or ignored.
• Double-tap on Addendum to display a dialog box listing your options.
• Highlight an item, and tap on OK.
When “Addendum” is set to Disabled the scanner does not recognize an addendum. If this
parameter is set to Optional the scanner searches for an addendum and if one exists, appends
it to the main bar code. When the parameter is set to Required the scanner does not accept
the main bar code without an addendum.
Transmit Code ID Char
A code ID character identifies the scanned bar code type. In addition to any single character
prefix already selected, the code ID character is inserted between the prefix and the decoded
symbol.
Add/Remove Data
Refer to “Add/Remove Data” on page C-14 for details.
C.5.5 EAN 8
Enabled
Set this parameter to on to enable “EAN 8”.
Include Check
If this parameter is enabled, the check digit is included with the decoded bar code data.
Addendum
See “Addendum” on page C-58.
Note: Setting Addendum to Optional will reduce performance. This value should only be
used if some bar codes actually have addendums.
Important: Before “Addendum” can take effect, the “Short Code” parameter (see
page C-55) must be enabled.