User's Manual

Warrington Hand-Held Computer User Manual 139
Chapter 6: Configuration
Decoded (Internal) – 2D Scanning Options
When this parameter is enabled, a bar code must be successfully scanned in both directions
(forward and reverse) before being decoded.
6.10.2.3 Decoded (Internal) – 2D Scanning Options
Scanning Mode
When you double-tap on this parameter, a dialog box is displayed in which you can choose
one of the following scanning modes: Smart Raster, Always Raster, Programmable Raster,
Slab Pattern, Cyclone Pattern, or Semi-Omni Pattern.
Raster Height And Raster Expand Rate
These parameters determine the laser pattern’s height and rate of expansion.
Double-tapping on this parameter displays a dialog box in which you can enter a value from
1 to 15.
6.10.2.4 Decoded (Internal) Data Options
Transmit Code ID Char
A code ID character identifies the scanned bar code type. In addition to any single character
prefix already selected, the code ID character is inserted between the prefix and the
decoded symbol.
When you double-tap on this parameter, a dialog box is displayed in which you can choose a
transmit code: None, AIM, or Symbol.
Scan Data Format
This parameter allows you to change the scan data transmission format. Double-tapping on
Scan Data Format displays the following options from which you can choose a data
format: data (as-is), data [S1], data [S2], data [S1][S2], [P] data, [P] data [S1],
[P] data [S2], and [P] data [S1][S2].
Prefix [P], Suffix [S1] And Suffix [S2]
A prefix and/or one or two suffixes may be appended to scan data for use in data editing.
When you double-tap on these parameters, a dialog box is displayed in which you can enter
a value from 0 to 255.
Note: These parameters are only used when either Programmable Raster or
Always Raster is assigned to the “2D Scanning Mode” parameter. “2D Raster
Height” and “2D Raster Expand Rate” are intended for very specific applications
and are usually not required for normal scanning purposes.
Preliminary Draft