User's Manual

Chapter 5: Getting To Know The Warrington
Pairing A Bluetooth Headset Or Other Bluetooth Device
72 Warrington Hand-Held Computer User Manual
also pair your hand-set with a Bluetooth headset. Refer to “Bluetooth Setup” on page 110 for
setup details.
5.9.1 Pairing A Bluetooth Headset Or Other Bluetooth Device
To pair a headset:
• Follow the headset manufacturer’s instructions to place the headset you want to place in
pairing mode.
•In the Control Panel, tap on the Bluetooth icon choose the Devices tab and scan for
devices in your area. (Note that if you’re pairing the device for the first time, the device
scan occurs automatically—you do not need to tap on the Scan button to perform
a scan.)
When the scan is complete, a list of devices is listed.
• Double-click on the headset you want to pair with. If you prefer, you can highlight
headset and tap on the Services button.
A dialog box appears requesting that you enter a PIN number.
• Type your pin number and tap on OK.
A Services dialog box appears listing headset.
• Press and hold the stylus on headset. In the pop-up menu, choose Active.
Your headset is now paired. A COM/BSP port name will now appear beside the service for
this device. An asterisk will appear under the Active list in the Service screen.
5.10 The MicroSD Card
A microSD card slot is available in the battery compartment. MicroSD cards provide addi-
tional, non-volatile memory to your hand-held.
5.10.1 Inserting The Card
• Switch off the Warrington.
• Remove the battery cover and the battery.
• Gently slide the SD door down and then flip it forward.
• Fit the card into the slot, pushing it inward to secure it in place.
• Flip the SD door back into place, and slide it upward to lock it.
Note: If the Bluetooth radio is not already enabled, tap on the Power icon in the Control
Panel, tap on the Devices tab and enable the Bluetooth radio.
Preliminary Draft