User's Manual

Chapter 5: Base Station Configuration
Radio Link Features
128
Teklogix 9150 Wireless Gateway User Manual
5.3.3 Radio Link Features
From the Radio Link Features option under Base Station Configuration (see Figure
5.2 on page 101), entering “Configure” will open the “Radio Link Features” page
for the polling and cellular parameters.
Operate in Cellular Mode
To operate as a Wlan base station, this parameter should be enabled ( √ ). For further
information see “Wlan Protocol” on page 11.
Note: The 9400 Network Controller must also be set to cellular mode.
Automatic Radio Address Assignment Range
Each Teklogix terminal using the radio link has a unique radio address number,
which can be assigned automatically by the 9150 by enabling this parameter.
Currently this feature is only supported through the 802.IQ protocol (for informa-
tion on 802.IQ configuration, see pages 64 and 192).
To enable this parameter, the values for the first and last radio address numbers
must lie between 1 and 3840. The default values for the range are 1024 ... 2084.
To disable the parameter, set the values to 0.
Notes: When enabling this parameter:
1. Direct TCP Connections for TekTerm must be disabled (see page 130).
2. The Auto ID parameter in the terminal must be enabled in order for
the radio address to be automatically assigned.