User's Manual

Chapter 5: Base Station Configuration
9010 / TCP/IP
136
Teklogix 9150 Wireless Gateway User Manual
Name
This parameter allows you to enter a name for the new host.
Enabled
The Enabled option must be turned on ( √ ) for terminals to communicate with
this host.
Emulation and Protocol
This parameter allows you to select the emulation and protocol to be used for the
connection to this host. For a network connection, use 9010/ TCP/IP.
Terminal Range
This parameter allows you to specify the range of terminals which will communi-
cate with this host. The left-hand textbox contains the lowest terminal number which
is allowed to communicate with the host; the right-hand textbox contains the highest
terminal number. Terminal numbers may range from 1 to 3840.
5.5.1.2 Emulation Options
Refrain from sending On-line & Off-line messages
If this parameter is enabled ( √ ), the 9150 base station does not notify the host if
the status of a terminal changes between offline and online. If this parameter is
disabled, the 9150 does notify the host regarding any terminal status changes.
The default for this parameter is disabled.