User's Manual

Chapter 6: Mini-Controller Configuration
3274/Telnet
162
Teklogix 9150 Wireless Gateway User Manual
Maximum Sessions per Terminal
This parameter contains the maximum number of telnet sessions which are allowed
to originate from each terminal. The range is 0 to 127, with a default value of 4.
First Local Terminal Port
This parameter contains the local port number from which the first terminal will
connect on outbound telnet sessions. The default value is 0.
Local IP Address to Bind
This parameter contains the IP address of the network adaptor in the 9150 from
which the first terminal will connect on outbound telnet sessions.
First Terminal Listen Port
This parameter specifies the first port number at which the 9150 will listen for telnet
connection requests to the terminals. To enable this parameter, the value must be a
minimum of 1024. To disable the listen port, the value must be 0.
The default value is 0 (disabled).
Actively Negotiate with Host
If this parameter is enabled, the 9150 starts negotiations with the host during setup
of the telnet connection. Not recommended for most hosts.
Send IAC Interrupt Process as a System Request
If this parameter is enabled, the 9150 sends the IAC Interrupt Process request to the
host as a 3274 System Request.
Send IAC Break as an Attention Key
If this parameter is enabled, the 9150 sends the IAC Break request to the host as a
3274 Attention key.
Auto-telnet
This parameter enables you to disable or enable automatic connection of telnet
sessions from terminals to this host.
The choices provided are: Disable and Auto-telnet. The default value is Disable.