User's Manual

Teklogix 9150 Wireless Gateway User Manual 177
Chapter 6: Mini-Controller Configuration
5250/Telnet
Host Port
This parameter allows you to enter a host port value for the selected 5250/Telnet host
connection. The default value is 23.
Maximum Sessions per Terminal
This parameter contains the maximum number of telnet sessions which are allowed
to originate from each terminal. The range is 0 to 127, with a default value of 4.
First Local Terminal Port
This parameter contains the local port number from which the first terminal will
connect on outbound telnet sessions. The default value is 0.
Local IP Address to Bind
This parameter contains the IP address of the network adaptor from which the first
terminal will connect on outbound telnet sessions.
First Terminal Listen Port
This parameter specifies the first port number at which the 9150 will listen for telnet
connection requests to the terminals. To enable this parameter, the value must be a
minimum of 1024. To disable the listen port, the value must be 0.
The default value is 0 (disabled).
Actively Negotiate with Host
If this parameter is enabled, the 9150 starts negotiations with the host during setup
of the telnet connection. Not recommended for most hosts.
Negotiate Virtual Device Name with Host
If this parameter is enabled, the 9150 negotiates with the host to obtain a virtual
device name for the telnet connection.